ANyone got a hole saw I can borrow?

[BlackPearl]

I bought some HID's for my car and need a hole saw to drill some holes behind my headlamp housing. Anyone here have one I can borrow? I only need it for a couple of hours once my HID's get here. Let me know, thanks!

[Dredz172]

I've got a couple of the attatchments that go into a powerdrill to cut holes.... they're probably too big, and have wood teeth on them.... what size do you want? i can check if have it

[XS CASH]

If he doesn't have it I probablly do just let me know what size. You cold also use a paddle bit depending on the material you need to drill.

[DustnF]

Make 3/4" hole...you need the hole to be big enough to push the connectors through. You can then buy rubber grommets from lowes or home depot to fill in most of the gap between the holes and the wires. After you are done you can use clear silicone to really seal it up...you are going to want to keep as much dust out of there as possible. You will probably have to remove the front bumper to find a good place for the HID power units. Have fun....it is not that bad.

[BlackPearl]

Wow, thanks guys. I bought them from a site sponsor on LSxGTO.com (Team SCCS) I was just informed today that the kit I want is on back order :( so the saw will have to wait.

As for the hole, someone online used a 5/8 hole saw with the exact kit that I bought. Thanks for all the help, but it may be awhile.

[SloNLo_350]

Who drills? I just left the little covers off. They have been in my glove compartment for over a year now. haha

Although apparently the body shop didn't know how to stuff the ballast back into that little area inside the fender, like I did it.