PDA

View Full Version : Thank you Tony!!!


Raptor05121
11-29-2009, 06:34 PM
I drove out of there with a smile on my face! That X3 Power Flash really woke my V6 up! :beer:

Any hints for the timing or A/F segment that I can adjust? I went ahead and put the global as +4 degrees and increased the A/F by +8% and I think I have a V8 now, but I dont wanna kill my engine either. :joystick:


Thanks again!
-Alex

P.S: Once I get some cash scraped up I wanna give a run on that dyno for kicks and giggles
Gt
11-29-2009, 07:06 PM
Without a wideband on it, I wouldn't adjust the A/F too much. Timing can be adjusted to your liking, if you hear any knock back it down 2 degrees. When we get it on the dyno I can optimize those settings for you.
Tally TransAm
11-29-2009, 07:28 PM
put it on the dyno or borrow someones wideband before you start fucking with it
Raptor05121
11-29-2009, 07:50 PM
alright, sounds good.

is there a special sequence to get the datalogging to run? I downloaded the software onto my laptop and have the SCT plugged into the truck with the key on and the SCT via USB into the computer but for some reason i cant figure out how to get the LiveLink to show real-time numbers
Gt
11-29-2009, 08:18 PM
Once you have it connected, Livelink, and the truck on. You need to select the icon that looks like a graph in the top corner. This will open the PID list. There are a LOT of things you can select to watch here. Speed wise keep it around 15 pids. Try and use the upper case PIDs only.
Raptor05121
11-30-2009, 04:13 AM
Once you have it connected, Livelink, and the truck on. You need to select the icon that looks like a graph in the top corner. This will open the PID list. There are a LOT of things you can select to watch here. Speed wise keep it around 15 pids. Try and use the upper case PIDs only.

gotcha. thanks again
fishin-nole
11-30-2009, 06:57 AM
So you have the dyno where you can get a truck on it now? Fepony is still wanting a new tune.
Gt
11-30-2009, 09:21 AM
So you have the dyno where you can get a truck on it now? Fepony is still wanting a new tune.

Not yet, just need a couple free days to make it work.
fishin-nole
11-30-2009, 10:20 AM
Cool, I told a couple guys over at one of the Lightning sites that you could not. Post up when you get it worked out.
LSCR351
12-01-2009, 12:02 AM
Yeah I called Friday and was told a truck couldn't be dynoed. I am ready to buy a SCT tuner and was asking about the posibility of a used one.