PDA

View Full Version : Dyno results...suck azz!


s10-den
10-09-2011, 09:19 AM
check this out. . . .
s10-den
10-09-2011, 12:15 PM
Took 9 runs to get to this point,still is FAR from being right.
spadoc79
10-09-2011, 08:57 PM
what kind of numbers were you expecting? what kinda setup you runnin?
NotoriousGreaseMonkey
10-10-2011, 06:51 AM
Chassis Dyno will break your heart every time.
Gt
10-10-2011, 08:28 AM
No reason for it to die @ 4650 power wise, seems like a spark blow out or valve spring problem. Would be nice to see what the A/F did across the run.
NotoriousGreaseMonkey
10-10-2011, 12:35 PM
Looks like the curve is smooth don't you usually have alot of skips and jumps when either one of those occour. Yes a A/F reading would be nice.
s10-den
10-10-2011, 01:29 PM
It should have been EASY 500 to the ground, or at least i would think!? Car has TFS170 heads,TFS Track Heat intake,comp 260 NX cam,TFS RR's,TFS pushrods, vortech S-trim with 2.75 blower pulley,7 inch crank pulley(only made 8 pounds) Meth injection,21* total timeing, power pipe,92MM MAF. 42# injectors,Walboro 255 HP pump,aluminum flywheel and 373's, 1 5/8 shorties,2 1/2 full exhaust out the back.
He said the A/F was at 11 or 12, I dont remember and dont know why is wasnt printed on that sheet... In was tuned at House of Boost in KC Missouri
s10-den
10-11-2011, 06:55 AM
clean out ya pm box Tony....LOL
Gt
10-11-2011, 03:29 PM
Done

Sent from my Droid using Tapatalk
Long_Stroke
10-12-2011, 09:05 AM
Yea, those are some horrble #'s for a boosted motor. Even if only at 9 psi.
s10-den
10-12-2011, 04:57 PM
Yea , I know. I think I may have the valves to tight, or the springs are not good enough. BUT, iI got some Anderson Ford springs coming to fix that problem...then see what happens again.
s10-den
11-16-2011, 07:02 AM
Ok, found out it was just the dyno, all is good!! I was scared.....LOL
DON'T ever believe what a dynacom dyno says.....Thats all I will say about that!!
Greg Kulbick
11-16-2011, 07:55 AM
Dyno-mite!
s10-den
11-17-2011, 09:45 AM
Dyno-mite!
:funny:
madderhatter
11-18-2011, 07:10 PM
Ok, found out it was just the dyno, all is good!! I was scared.....LOL
DON'T ever believe what a dynacom dyno says.....Thats all I will say about that!!
New numbers ?